Comfort Hoof Care, Inc. Accu-bond

Trim, rasp, or grind to balance the claw, as level as possible. Sand and clean thoroughly. Dry claw with a heat gun. To open the cartridge, cut the tip at the line with sharp nippers. Insert cartridge into dispensing gun, label side up. Before attaching the mixing tip, equalize the cartridge by squeezing out a small amount to ensure that both sides are dispensing evenly.
Use only Accu-Bond mixing tips. Attach a mixing tip by pressing and twisting clockwise. Heat the synthetic or wood block for 15 seconds with heat-gun or keep in heated container. Apply 30 to 50 ml of Accu-Bond onto warm block. Position block on prepared claw. Ensure 1/8 inch to 3/16 inch width of Accu-Bond between block and bottom of claw. Hold until bond begins to cure; then press firmly for 30 seconds. If possible, let Accu-bond cure for 2 to 3 minutes before releasing leg and allowing them to make contact with ground.