These boots are a fast, effective and economical way to mix acrylic powder and liquid in the proper amounts. A neutral block, it fits the left or right claw, so no need to carry both sizes. Simply insert the desired sized wooden block into the mixing boot and apply directly to the claw/hoof. It creates a rolled toe for better break-over while walking.
Labeled for: beef and dairy cattle
Species: cattle
Pour 1 capful of liquid up to the line in the mixing toe; approximately 25 ml. Pour about 50 g of powder into the mixing toe. Leave some room for mixing. Use mixing stick to gently push powder into liquid. Once a majority of powder is in liquid, mix quickly. Use stick to push substance to the top of the mixing toe.
Slide wood block into the bottom of the mixing toe. Use mixing stick to pull mixture onto block, 3/4 of the way leaving about an inch of block exposed. Quickly apply block to good claw using mixing toe as a guide around the hoof. Be sure to not press too hard; leave about 3/16 of an inch of glue in between the claw and block.
Use the mixing toe to smooth excess glue around the claw to help hold the block on. Keep the hoof in the air for 2 to 3 minutes, allowing the adhesive to dry and harden. Release hoof quickly allowing cow to put weight entirely on block. Allow cow to adjust weight to the block for a few seconds to make sure block stays on. Release cow from holding chute.
What others are saying
There are no contributions yet.