Hoof Tite Mixing Tubes are designed for use with Hoof Tite Block Adhesive. Allows proper and controlled application of adhesive to hoof blocks for the best results. The two-part block adhesive mixes in the tube for even distribution on wooden or plastic blocks. Dual chamber mixing tips are 6-inches in length to prevent contamination.
Species: cattle
Works with all Hoof Tite Block Adhesive, except Hoof Tite Max Mix Adhesive.
Treat the injured claw as necessary. Then trim the sound claw and ensure it’s as flat, clean, and dry as possible. Place the Hoof Tite cartridge into the applicator gun. Untwist round cap and remove dual plug; then place the mixer tip. Slide cap around the mixer tip and twist the cap to secure. Dispense through gun. Replace dual plug and secure with cap.
Application: Apply block immediately to prepared sound claw. Hold firmly for 30 seconds do not press glue between hoof and block because the layer of glue may become too thin. After setting, let the cow stand on the block for 2 to 3 minutes before releasing.
What others are saying
There are no contributions yet.